Sunbeam Waffle Iron 2600 User Manual

Ultura 2600 Platinum  
Dry Iron  
Instruction Booklet  
SR2600  
Please read these instructions carefully  
and retain for future reference.  
 
Sunbeam’s Safety Precautions  
SAFETY PRECAUTIONS FOR YOUR IRON.  
• Do not leave the iron unattended while it is  
plugged into the power outlet.  
• The iron must be used and rested on a stable  
surface.  
• Do not leave a hot iron within reach of children.  
If they come into contact with a hot iron it  
could lead to serious burns.  
• Iron only on an ironing board.  
• When placing the iron on its stand, ensure that  
the surface on which the stand is placed is  
stable.  
• The iron is not to be used if it has been  
dropped, if there are visible signs of damage or  
if it is leaking.  
• An iron takes approximately 30 minutes to  
cool down. Allow the iron to cool completely  
before storing.  
• Do not wind the cord around the  
soleplate while the iron is still hot.  
Sunbeam is very safety conscious when designing  
and manufacturing consumer products, but it is  
essential that the product user also exercise care  
when using an electrical appliance. Listed below are  
precautions which are essential for the safe use of  
an electrical appliance:  
• Do not use an appliance for any purpose other  
than its intended use.  
• Do not place an appliance on or near a hot gas  
flame, electric element or on a heated oven.  
• Do not place on top of any other appliance.  
• Do not let the power cord of an appliance hang  
over the edge of a table or bench top or touch any  
hot surface.  
• Read carefully and save all the instructions  
provided with an appliance.  
• Always turn the power off at the power outlet  
before you insert or remove a plug. Remove  
by grasping the plug - do not pull on the cord.  
Turn the power off and remove the plug when the  
appliance is not in use and before cleaning.  
• Do not use your appliance with an extension cord  
unless this cord has been checked and tested by  
a qualified technician or service person.  
• Always use your appliance from a power outlet of  
the voltage (A.C. only) marked on the appliance.  
• This appliance is not intended for use by persons  
(including children) with reduced physical,  
sensory or mental capabilities, or lack of  
experience and knowledge, unless they have been  
given supervision or instruction concerning use  
of the appliance by a person responsible for their  
safety.  
• Do not operate any electrical appliance with a  
damaged cord or after the appliance has been  
damaged in any manner. If damage is suspected,  
return the appliance to the nearest Sunbeam  
Appointed Service Centre for examination, repair  
or adjustment.  
• For additional protection, Sunbeam recommend  
the use of a residual current device (RCD)  
with a tripping current not exceeding 30mA in  
the electrical circuit supplying power to your  
appliances.  
• Do not immerse the appliance in water or any  
other liquid unless recommended.  
• Appliances are not intended to be operated by  
means of an external timer or separate remote  
control system.  
• This appliance is intended to be used in  
household and similar applications such as: staff  
kitchen areas in shops, offices and other working  
environments; farm houses; by clients in hotels,  
motels and other residential type environments;  
bed and breakfast type environments.  
• Children should be supervised to ensure that they  
do not play with the appliance.  
• The temperature of accessible surfaces may be  
high when the appliance is operating.  
• Never leave an appliance unattended while  
in use.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
1
 
Features of your Ultura Dry Iron  
Thermostat light  
Temperature indicator  
Long cord with swivel cord outlet  
Illuminates to indicate  
that the iron is heating  
and goes out when  
Align the desired setting  
with the temperature  
indicator.  
The swivel cord outlet is ideal for left  
or right hand use, and provides greater  
versatility and ease of movement when  
ironing. The flexible grommet protects  
the cord from fraying.  
it has reached the  
temperature selected on  
the temperature dial. The  
thermostat light cycles  
on and off during ironing  
as the iron maintains the  
selected temperature.  
Temperature dial  
Allows you to select  
the desired  
temperature for  
each garment.  
s
Stable heel rest  
Large heel rest  
keeps the iron  
stable on the  
ironing board.  
Figure 1  
Teflon® Platinum Pro  
non-stick soleplate  
Glides easily across  
all types of fabric and  
prevents sticking.  
Full length button groove  
For ironing around  
buttons.  
Cord wrap facility  
The built-in cord wrap  
facility allows you to wind  
the cord around the heel for  
neat and tidy storage of the  
cord when the iron is not  
in use.  
2
 
Using your Ultura Dry Iron  
Before first use  
2.Turn the temperature dial to the desired  
setting by aligning the setting on the dial with  
the temperature indicator. The thermostat  
light will illuminate to indicate that the iron  
is heating to the selected temperature. When  
the thermostat light goes out the iron is at  
the selected temperature and is ready to iron.  
Remove any adhesive stickers, plastic covers  
or cardboard sleeves from the soleplate.  
Ensure that all adhesive is removed by  
rubbing the soleplate with a cloth  
dampened with methylated spirits.  
NOTE: When turned on for the first time,  
your new iron may give off vapours for up  
to 10 minutes. This is due to the initial  
heating of the materials used. It is safe, not  
detrimental to the performance of the iron,  
and will not reoccur.  
NOTE: When the temperature dial is changed  
from a high setting to a lower temperature  
setting during ironing, the thermostat light  
will go out immediately. This indicates  
that the iron is cooling to the selected  
temperature. To ensure that the iron has  
reached the selected temperature and is not  
too hot, wait until the thermostat light comes  
on again and then goes out before ironing.  
Using your iron  
1.Insert the 3 pin plug into a 230/240 volt  
power outlet and turn the power on.  
Care and Cleaning  
After each use  
1.Turn the power off and remove the plug  
from the power outlet.  
Cleaning the Teflon® Platinum Pro non-stick  
soleplate  
The non-stick coating reduces sticking of  
fabrics and starches to the soleplate. Do  
not iron over sharp objects such as buttons,  
studs and zippers, as these will scratch the  
surface.  
2.Allow the iron to cool before winding  
the cord around the built-in cord wrap.  
Storage  
Always store the iron on its heel rest.  
Wipe the soleplate with a damp soft cloth  
after each use. If polyester has burnt to the  
soleplate, iron a damp cotton cloth while hot.  
NOTE: Do not store the iron with the soleplate  
facing down, or in the carton.  
Cleaning  
Caution: Do not use scouring pads, abrasives  
or harsh cleaners to clean your Teflon®  
Platinum Pro soleplate, as these will scratch  
and damage the surface.  
To clean the exterior of your iron, wipe  
over with a damp soft cloth and wipe dry.  
Caution: Do not use harsh abrasives, chemical  
cleaners or solvents to clean the exterior of  
your iron as these will damage the surface.  
3
 
Ironing Guide  
Selecting ironing temperature  
Always read garment labels and follow the  
manufacturer’s ironing instructions.  
• When reducing the temperature to iron  
sensitive fabrics, allow approximately 2  
minutes for the iron to cool to the new  
setting.  
• Pure woollen fabrics (100% wool) can be  
ironed with the temperature dial set to  
Wool. Use an ironing cloth to prevent shine  
marks on the fabric.  
• Fabrics such as velour, wool, linen and silk  
are best ironed with an ironing cloth to  
prevent shine marks.  
• Never iron areas of a garment where  
perspiration marks are visible, as the heat  
of the iron will fix the stains, making them  
permanent.  
Hints for easier ironing  
• Sort articles to be ironed according to the  
type of fabric. This will reduce the need  
to adjust the temperature to suit varying  
garments.  
• Start with garments requiring lower  
temperatures and work your way through to  
items requiring higher temperatures.  
• If you are unsure of the fabric content of  
a garment, test a small area such as a  
seam or inside hem section before ironing  
a visible area. Start with a low temperature  
and gradually increase the heat to find the  
best setting for ironing the garment.  
4
 
2 Year Replacement Guarantee  
In the unlikely event that this appliance develops any malfunction  
within 2 years of purchase (3 months commercial use) due to  
faulty materials or manufacture, we will replace it for you  
free of charge.  
Should you experience any difficulties with  
your appliance, please phone our customer  
service line for advice on 1300 881 861 in  
Australia, or 0800 786 232 in New Zealand.  
Alternatively, you can send a written claim  
to Sunbeam at the address listed below.  
On receipt of your claim, Sunbeam will  
seek to resolve your difficulties or, if the  
appliance is defective, advise you on how  
to obtain a replacement or refund.  
In Australia you are entitled to a  
replacement or refund for a major failure and  
for compensation for any other reasonably  
foreseeable loss or damage. You are also  
entitled to have the goods repaired or  
replaced if the goods fail to be of acceptable  
quality and the failure does not amount to  
a major failure.  
Should your appliance require repair or  
service after the guarantee period, contact  
your nearest Sunbeam service centre.  
Your Sunbeam 2 Year Replacement  
Guarantee naturally does not cover misuse  
or negligent handling and normal wear and  
tear.  
For a complete list of Sunbeam’s authorised  
service centres visit our website or call:  
Australia  
Similarly your 2 Year Replacement Guarantee  
does not cover freight or any other costs  
incurred in making a claim. Please retain  
your receipt as proof of purchase.  
1300 881 861  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
The benefits given to you by this guarantee  
are in addition to your other rights and  
remedies under any laws which relate to the  
appliance.  
New Zealand  
0800 786 232  
26 Vestey Drive, Mt Wellington  
Auckland, New Zealand  
Our goods come with guarantees that cannot  
be excluded under the Australian Consumer  
Law and under the New Zealand Consumer  
Guarantees Act.  
 
Need help with your appliance?  
Contact our customer service team or visit  
our website for information and tips on  
getting the most from your appliance.  
In Australia  
Or call 1300 881 861  
In New Zealand  
Or call 0800 786 232  
is a registered trademark.  
‘Ultura’ is a registered trademark of Sunbeam Corporation.  
Made in China.  
Due to minor changes in design or otherwise,  
the product may differ from the one shown in this leaflet.  
© Copyright. Sunbeam Corporation Limited 2010.  
ABN 45 000 006 771  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
Unit 3, Building D  
26 Vestey Drive  
Mt Wellington Auckland  
New Zealand  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
8/11  
 

Sennheiser Network Router LSP 500 PRO User Manual
Sharp CRT Television 25N S100 User Manual
Snapper Lawn Aerator 3882 User Manual
Sony Flat Panel Television XBR 55HX950 User Manual
Sony Photo Printer Professional Photo Printer User Manual
Sony Stereo Receiver STR DH740 User Manual
State Industries Electric Heater GS6 40 YBVIT GS6 40 HBVIT GS6 50 YBVIT GS6 50 HBVIT GS6 40 YBVIT 2 GS6 40 HBVIT 2 GS6 50 YBVIT 2 GS6 50 HBVIT 2 User Manual
Sunrise Medical Mobility Aid Quickie S 525 User Manual
SVAT Electronics Home Security System 24 GHz Wireless B W Security System User Manual
Tanaka Trimmer TBC 255PF User Manual